INSTALLING THE REMOTECONNECTING THE SUBWOOFER
LEVEL CONTROL TO BASSPRO
The Subwoofer Level Control may beChoose a mounting location thatRoute the cable behind the dash or
mounted under the dash or dismantledallows easy access to the control, other interior panels and under theBassPrBassPro Connection Panelo Connector Panel
and mounted in the dash for a factory-and provides 1-3/4" clearance behindcarpet. Do not route the cable outside
installed appearance.the mounting surface. Drill a 9/32" the vehicle. Connect the RJ11 cable
hole in the mounting surface. Feed between the RJ11 receptacle on the
UNDER-DASH MOUNTING the Subwoofer Level ControlOs BassPro and the receptacle on the
Select a mounting location that allowspotentiometer shaft (with the knobSubwoofer Level Control (Figure 6).
easy access to the control while driv-removed) through the hole and use the
ing. Using the Subwoofer Level Controlnut and washer provided to hold the
as a template, mark and drill holes incontrol in place (Figure 5).
the mounting surface. Attach the
Subwoofer Level Control using the
mounting screws provided (Figure 4).
IN-DASH MOUNTING
Disassemble the Subwoofer Level
Control by removing the two Phillips-
head screws on the front panel,
rear panel and on top. Remove the
Subwoofer Level ControlOs bottom and
Control
side panels. Slide the Subwoofer LevelCable
ControlOs PC board forward to release
the RJ11 connector from the back
panel and remove the board along with
the potentiometer, knob and connectorSocketSocket
as a single assembly. for for
Control
ControlCable
Cable
Rear View of
Level-Control
Circuit Board
Figure 6. Subwoofer Level Control electrical
WasherLevelWasherLevel-connection.
Control
Control
CircuitCircuit
Board
Hex NutHex NutBoard
KnobKnob
Figure 5. In-dash mounting of the Subwoofer
Level Control.
Figure 4. Under-dash mounting of the
Subwoofer Level Control.
6 |